Pay in 4 interest-free payments of $42.25 Learn more
Ships within 48 hours · Estimated delivery Aug 18 - Aug 23
0 probe Good general-purpose EC measurement range Analog output Easy to connect to controller boards Temperature compensation support Better stability in changing conditions BNC probe connection Secure and service-friendly interface Note Use the official DFRobot resources below for wiring
5 Hz update rate
Use a suitable external power source for motion parts when the controller alone cannot supply enough current
The power of gravity is used by a tilt switch SW200D to identify changes in orientation
DFRobot Gravity Rain/Steam/Water Sensor - Moisture Detection 830 point 0 probe Good general-purpose ECAdd Reliable Rain Steam Water Sensor Gravity Sensing to Your Next Build This is a steam(water)sensor from DFRobot. This steam sensor can be connected to the Arduino IO Expansion shield directly. The output voltage will increase when the humidity of the sensor surface goes up. Notice: The new version of analog sensor port pin mapping has been changed as the following two features. Please check the tips for changing sensor cable pin mapping while using
